Pneumercator TMS2000 Quick Start Up Manual - page 10
Quick Start-up Guide
TMS Series
TMS Quick Start-up Guide.docx
Page 10 of 24
November 21, 2017
Programming Float Height Offsets using TMS Front Panel
Refer to the Figure 5 below for the relative locations of the buttons. Note that each button has three
labels depending upon your display status. Without entering programming mode, the main labels
printed on the buttons are used. Once in programming mode, a nonflashing display represents
Review Mode where a flashing display represents Edit Mode. Note that this represents the latest front
panel button configuration available. Earlier systems maintained the same labeling system but had
physically different buttons.
Figure 5 - TMS Front Panel Keys Layout (TMS3000 colors shown)
1) Enter programming Mode by pressing and holding the TEST button and then pressing the
MODE button at the same time until Log (Log) appears. Release both buttons.
2) Press the EDIT (TEST) button repeatedly until Config (Config) appears flashing.
3) Press the ► (MODE) button one time. Header (Header) appears.
4) Press the EDIT (TEST) button repeatedly until Probe (Probe) appears flashing.
5) Press the ► (MODE) button one time. The value for Probe CF for Tank Channel 1 is displayed.
6) Press the GROUP SELECT (TANK SELECT) button until the desired Tank Channel number is
displayed over the TANK ID label on the display.
7) Press and hold the STEP (MODE) button until it beeps ONE TIME and immediately release the
button. Repeat this twice more and Prod HO (Prod HO) will appear briefly then the current value
for the Product Float Height Offset will appear. Note that this number will start with a + (+) or a -
(-) sign indicating a positive or negative number.
DWG NO. 20043 REV. N/C
REVIEW
EDIT
STEP
GROUP SELECT
EDIT
TEST
MODE
TANK
SELECT