1 user manual pni-zm101-ev zigbee tm -ready wireless network evaluation board using the uz2400 rf chip and the 78k0r/ke3 microcontroller.
2 1 sample application two sample applications are included in this evaluation kit. • rf test program • mac library sample program: send and receive message. A ieee 802.15.4 compliant mac library is included in this evaluation kit. It is a linkable object-code library. “c” source code is provided fo...
3 table 1 hyperterminal port configuration. Baud rate 19200 data bits 8 parity none stop bits 1 flow control none local echo off line feed no 1.1 rf test sample application two pni-zm101-ev boards are required to conduct this test. J5 to j8 is used to setup the board 4 lsb address. Set one unit’s ad...
4 port or com port, you shall be the following screen. If not, please push the reset button. 1.1.1 packet error rate (per) test to start the per test, first start the receiver board, the board with short address “0002”, press 2 to initiate the receiver loop back function and in the menu of the trans...
5 - the number of packets received. - the calculated per in %. - the maximum and minimum rssi values in this per test rssi is received signal strength indication. For the detail of the rssi value, please refer uz2400 rf chip’s datasheet. 1.1.2 continuous tx / pseudo noise the menu item “3” initiates...
6 the menu item “9” set the rf channel. The default rf channel is set channel 11. It is assigned to rf frequency at 2405mhz, you can change the channel in 5mhz step to the maximum channel at 2480mhz (channel 26). To do it, please press “9” in the command prompt. Then, choose the channel by [+], [-],...
7 now you shall find the following message in the hyperterminal, if not, reset the evaluation board..
8 1.2.1 designation of a coordinator now you choose a board to be a coordinator and in the hyperterminal which is connect this board type “c” to enter coordinator mode. When successfully started as a coordinator, the return status shall be 00. The coordinator is ready to accept end device’s associat...
