PNI PNI-ZM101-EV User Manual - page 4
of
8
4
port or COM port, you shall be the following screen. If not, please push the
reset button.
1.1.1 Packet Error Rate (PER) Test
To start the PER test, first start the receiver board, the board with short
address “0002”, press 2 to initiate the receiver loop back function and in the
menu of the transmitter board, the board with short address “0001”, press 1
to setup PER test. The first prompt ask you to input the destination short
address, you may input “0002”, then you will be asked number of packets to
send during this PER test. Next, you will be prompted to input the interval
between two packets in ms and you may input 1 or larger value. When the
PER test finish. You will see:
- The number of packets sent.