POCKetec POCKEY User Manual - page 10
10
SOFTWARE INSTALLATION FOR MACINTOSH®
The Pockey is compatible with Mac OS 8.6 and
higher. Software drivers must be installed for Mac
OS 8.6 to 10.0. Software drivers are not required for
Mac OS 10.1. For driver installation, please follow
steps 1 through 7 below.
1. Place the CD ROM installation disk onto the
sliding tray of the CD ROM drive or for front-
loading CD ROM drives, download drivers from
www.pocketec.net
.
Note: The mini-CD cannot be read by front-loading
CD ROM drives of Macintosh® computers and
may jam the drive. Unless the CD ROM has a tray
that slides out for the CD, do not use the mini-CD
provided in your Pocketec™ package.
2. Open the “Mac” folder and unzip “Pockey.HQX”
using “Stuffit Expander”.
3. A new file named “Install ISD USB-IDE Bridge”
will be created.
4. Double click this file to install the Pockey driver.
5. You will see the message “Installation was
successful”. Click “OK”.
6. Connect the Pockey to your computer’s USB
port and turn the power switch to “USB”, or if
your computer requires use of the Supplemental
Power Cord, turn the power switch to the “EXT”
position.
7. Your computer will recognize the Pockey.