ProTerm RAY 9-24K User And Installation Instructions Manual - Dear Customer
Supplied By www.heating spares.co Tel. 0161 620 6677
2
DEAR CUSTOMER
You have just become the owner of a direct heating electric boiler which was designed for central heating systems
with a user friendly regulation option for thermal comfort.
PROTHERM wants your electric boiler to serve you at a high level of efficiency. In order for it to do so, it is
necessary to adhere to certain principles when installing and operating the boiler. Therefore we would ask you to
carefully read the operating instructions and put them into use during operation.
We believe that our PROTHERM electric boiler will bring about optimal thermal comfort and result in a truly
pleasant environment.
We would ask you to pay close attention to the following important points:
1. The boiler and all related equipment must be installed and made use of in accordance with the design, all relevant
valid regulations and technical standards and according to the manufacturer’s directions.
2. The boiler can only be installed in an environment it has been designed for.
3. The installation and initiation (or later restarting) of operation can be only undertaken by a professional individual,
authorised by the manufacturer.
4. Please,refer to a professional authorized by the manufacturer in case of failure – unprofessional intervention can
lead to damage to the boiler (or – eventually – to the related equipment)!!
5. Check if all parts have been supplied.
6. Check,if the supplied boiler type corresponds with the type required for use.
7. When uncertain about boiler operation, please, do not neglect to look up and study all relevant information
located in the operating instructions and carry out everything in accordance with them.
8. Do not remove or damage any labels or written notices on the boiler.
9. The boiler complies with the following standards: CSN EN 60335 – 1: 1997 CSN EN 50081 – 1:1994, CSN EN
55014-1:1995, CSNEN 61000-3-2+A12:1997, CSN EN 61000-3-3:1997CSN EN 55 014-2:1998, CSN EN 06
1008:1997.
10. At the end of its service life the boiler and its parts should be treated with respect to the environment.
1. INTRODUCTION
In accordance with development trends in the area of electric boilers, PROTHERM company has introduced
electric direct heating boilers of the REJNOK series, produced in 9, 12, 15, 18, 21 and 24 kW versions.
This boiler has a high utility value, i.e. it is well equipped, which makes it independent of the heating system
equipment. Through the use of a simple control panel it is possible to adjust the boiler operation according to the
conditions of the given building.
1.1. QUALITY ASSURANCE OF EQUIPMENT AND PERSONAL SAFETY
In addition to the requirements of the above mentioned documents, it is necessary to adhere to these instructions
and the accompanying manufacturer’s documentation of the boiler while using this boiler. Also essential is intervention
by children, intoxicated persons, irresponsible persons, etc.
The manufacturer’s products conform to the standards of the examined type through maintaining technological
discipline through its quality control system in accordance with the ISO 9001 standard.
A constant high level of care for the product and the user (i.e. on installation, placing into operation, acquaintance
with usage, setting and regulation in accordance with local conditions, during the warranty and after warranty
period) is provided by a network of contract partner companies with qualifications in correspondence.