Protex DigiPaz-309 Programming And Operations Manual

Using the power override wire

If your keypad does not respond, don’t be alarmed. Most likely

the batteries are dead and need replacing.

You will be able to open the safe using the power override wire

as follow:

fig.5

fig.4

NEVER LOCK THE OVERRIDE WIRE INSIDE THE SAFE

Two Prongs

1. Take a 9V battery and plug it in the 

     power override wire connector as 

     shown in fig.5

2.  Locate the connector under the

     keypad and plug it in snugly, 

     making sure that the two prongs 

     go into the two tiny holes. See

     fig.4

3.  While the battery is plugged in, go a head 

     and enter your 6 digit code as you normally

     would and open the safe.

4.  Now you can replace the batteries inside

     the safe by referring to the previous page

     in this manual.

Plug the override wire to the keypad with red wire 

to the right.

The override wire is only to be used in an emergency 

when the internal batteries die or very low.

Unplug the override wire after replacing the internal 

batteries.

feature is used to 

give power to the 

lock from the outside 

of the safe when the 

internal batteries are

dead.

The battery override 

-5-

LED Interior Light System (Optional)

Adjusting the shelves: 

You may have purchased your safe with an optional LED interior light 

system installed.

The LED interior light will go on for 30 seconds after the safe is opened.

You can toggle the light ON and OFF by pressing the # key during those 30 seconds.

The power for  LED light system is coming from the same batteries that power 

the keypad lock.

Since it’s a very low power consumption light system, it will not drain the batteries 

any faster then it would without the light.

It is best to shut off the light after closing the door by pressing the # key once. 

The blue LED light on the keypad will stay “on” when the interior light is “on”.

The safe model you purchased may include 

adjustable velvet shelves. 

These shelves may be adjusted to various heights,

by changing the position of the lower shelf clip on 

the side rails, see fig.6

You may dispose of the top (90 degree angle) clip

as it is used for shipping purposes only. 

Top clip

(Okay to dispose)

Lower shelf clip,

used to hold the shelf

-6-

TIPS:

fig.6

http://www.monomachines.com/

http://www.monomachines.com/