Protex DigiPaz-309 Programming And Operations Manual - page 3
Enrolling / Changing a code
Enrolling a new code for the first time
Changing your code
IMPORTANT:
TIPS:
1. Open the door and turn the handle so the bolts are out (Locked position).
2. Press and then # (This will enter the lock into a code-change
mode)
3. Now enter the factory default code (1-2-3-4-5-6) and press the
# key. (Two beeps will sound)
4. Enter your new 6 digit code and press the # key, Enter your new
6 digit code again (for the second time) and press the # key.
Two beeps will sound indicating the acceptance of the new code.
5. Check your new code by pressing your new code an then #.
Repeat steps 1-6 on this page except enter your existing code (the code
you are using to open the safe) instead of the factory code in step 3.
Do not pause for more then 7 seconds when you do steps 2-4.
We recommend that you right your new 6 digit code on a piece
of paper to avoid any errors when programming.
Your code must consist of 6 digits
Always press the # key after the 6th (last) digit
Do not use the key or the # key as part of your 6 digit code
If you make a mistake in the middle you can always press the key
to clear and start over.
Check your new code at least 3 times with the door open before you
close the safe.
paper it’s written on,
NEVER
LOCK YOUR CODE INSIDE THE SAFE.
Always make sure to remember your new code and destroy the piece of
*
*
*
*
-3-
Notes
Serial Number:
Model Number:
Date of Purchase:
Notes:
-8-
http://www.monomachines.com/
http://www.monomachines.com/