Protocol Dronium Two AP Instruction Manual - page 5

REMOTE BATTERY INSTALLATION

1. Install batteries carefully.

2. Do not mix old and new batteries.

3. Do not mix different types of batteries.

Unscrew and remove battery cover from controller.  Insert 4 x ‘AA’ batteries 

according to indicated polarities.  Replace and screw back in battery cover.

4

5

PARTS

LCD SCREEN

01. Trim: Side-to-side Banking (defaults to center on start-up)

02. Trim: Forward/Backward (defaults to center on start-up)

03. Trim: Turn Left/Right (defaults to center on start-up)

04. Throttle (remains at center)

05. Throttle (defaults to zero on start-up)

06. Directional Display (defaults to center on start-up)

07. Banking Movement to Right

08. Backward Movement

09. Banking Movement to Left

10. Right Turn Movement (defaults to zero on start-up)

11. Left Turn Movement (defaults to zero on start-up)

12. High Speed Mode Active

13. Low Speed Mode Active

14. Controller battery Level Indicator

15. Flight Mode 1 Active (Default); To change to Mode 2, press and  

  hold Mode Switch to the right while turning on the transmitter.

16. Remote control signal strength

17. Indicates positive communication lock with the Dronium Two AP

4 x ‘AA’ Batteries

Battery Cover