Protocol Dronium Two AP Instruction Manual - page 7
POWER-ON PROCEDURE
NOTE
1. While the drone is in process of synchronizing, the lights will flash.
When the process is completed, the lights will remain steady. This is
your indication that the process is completed.
2. If after 30 seconds, it has not recognized the drone, turn off the
controller and repeat Power-On prodedure.
Before flying, the drone and transmitter must be turned on in sequence and
synchronized.
1. Turn on the drone and place it on an even surface.
2. Turn on the remote control.
3. Both indicators on the drone and the remote will flash.
4. Push the throttle up and then down to sync. You will hear two beeps and
the lights will go steady.
Tip: When syncing your drone keep it in a horizontal position for stable flight.
CHARGING THE DRONE BATTERY
CAUTION WHEN CHARGING
1. When charging, place product on a dry, well-ventilated surface and
keep away from heat sources.
2. Always use adult supervision while charging.
3. In order to increase battery longevity, avoid repeat charging and
excessive discharging.
4. As battery temperature is high immediately after flight, charge after
cooling down for higher efficiency.
5. Do not strike or subject battery to hard impacts or sharp surfaces.
6. Do not use any other charger than that which is supplied with
this item.
7. Do not use or leave battery near a heat source such as fire or space
heater; exposure to heat may result in reduced performance or in
some cases dangerous conditions.
8. If battery is left in charging state for an extended period of time after
being fully charged, the battery may automatically discharge.
9. Never leave the battery unattended during charging.
10. Do not disassemble battery.
11. Do not submerge battery in water.
8
9