ProWine n2Vin Operation Manual - page 28
n
2
Vin
Setup and Operations Manual © 2008
28
Quick Start Guide
REMOVE FROM BOX
Cut the 2 plastic straps on the carton and slide the outer box up and off the n2Vin.
Slide the protective plastic bag off of the n2Vin and remove loose accessories.
Lift the system out of the packing base and put it on a counter or stand.
POWER ON
Plug the power cord into the rear inlet at the back of the cabinet, then to an outlet.
Push & hold in POWER Button
to turn system ON – release once ON.
Push & hold SET until temperature flashes. Arrow up or down to desired temperature and
re-press SET quickly to store the new value.
NITROGEN SETUP (You did get a cylinder, right?)
Clip the ziptie holding the nitrogen tube to the back of the cabinet.
Push the nitrogen tube fully onto the regulator barb - if using standard regulator.
Inspect the o-ring on the cylinder nipple on the regulator. If OK, insert & screw the
handwheel into the cylinder valve tightening firmly hand tight. If the o-ring is damaged,
replace it first. (#-110 – 3/8” X 9/16” X 3/32” wall)
Put the nitrogen cylinder somewhere it won’t fall on your foot – standing or horizontal.
Close
RED
regulator knob then reopen 3 1/8 full turns. That will be ~4psi.
Turn Master Gas Valve (lower left of dispensing panel) DOWN/OFF.
Turn or slide each of 5 Bottle Head Valves DOWN/OFF.
Turn nitrogen cylinder valve ON to see contents needle move to full – note the position.
Close cylinder valve – you are doing a quick connection leak check
1
.
BOTTLE SETUP
Clip & remove the 5 zipties holding the 5 Bottle Heads, leaving Heads on Hanger Rail.
Let’s just use a bottle of water for
now!
Remove one head from the hanger
Rail and stick it & its tube into the
bottle. (Bottle can be on counter.)
Turn the Compression Wheel CCW
until firm.
You should be able to pickup the full
bottle by the Bottle Head.
Turn the Bottle Head valve ON.
Put the bottle into the cabinet.
DISPENSE
1
Look at the Contents Gauge on the Regulator. It should not have moved.
Turn the Master Gas UP/ON – now the gauge needle should drop!
Re-open the Nitrogen cylinder valve – gauge pops back up!
Push a glass into the cup-trip Tap and fill it! You’re n2Vin! (OK water, but we’re close!)
Got it? Great! What was that 20-25 minutes start to finish?
Now do you and your wine a favor: Drink some & read this guide…