Proxima Nadir PX102 Operation Manual - page 12
10
6.2. PROGRAMMING SPECIAL SCENES
The internal effects generator contains following movements : figure 8 , circle and diagonal. Special scene
programming incorporates assigning one of those movements to a selected program, and defining
parameters such as speed, diameter, and location of the center of the movement.
NOTE !
Special scene programming may only be done in programs 49-64.
NOTE!
To avoid conflict during playback of different programs controlling both scanners and dimmers, the PAN and
TILT setting should be set at neutral (128). This is done by pressing the joystick.
In programming different movements for a number of
fixtures it is important to know the start of the program.
Press D to activate start synchronization.
To program movement in opposite directions in the same program :
1. Select fixtures that are to move to the right
2. With the C button select O+ on LCD display..
3. Adjust speed and diameter.
4. Turn off fixture LEDs. The fixtures will continue their movement.
5. Select fixtures that are to move to the left.
6. With the C button select O- on the LCD display.
7. Adjust speed and diameter..
8. Press ENTER to record all the settings.
With C select following effects :
O+ - circle to the right
O - - circle to the left
8+ - 8 to the right
8- - 8 to the left
/+ - diagonal to the right
\- - diagonal to the left
C
Press A or B to select the program.
Select fixture(s) to be programmed by pressing
corresponding fixture buttons.
NOTE!
Each program may control up to 64 fixtures.
Set faders DIAMETER and RATE ( speed ) at 0.
NOTE!
Press E (Del) to delete any DMX values previously set
in the selected program.
Set diameter and rate (speed)
faders. Set the center of the
movement with the joystick.
Save all changes by pressing
ENTER.
DIAMETER
C
C
A
B
A
B
E
E
F
F
X: 0 Y: 0 D: 52 Rt: 8.1
Select fixtures
Pgm. 49 8+ ! Del. ED
Pgm. 49 8+ ! Del. ED
D
D
X
F
A
D
E
R
A
T
E