PRSS contentdepot IDC SFX4104 Installation Manual - page 19
ContentDepot Installation Guide
15
Step 5 Configure Network Settings for the Receiver
The preconfigured network settings for the Pro Audio receiver are as follows:
Windows workgroup = ContentDepot
Eth0 (NET 1) IP Address/netmask = 192.168.29.52/255.255.255.0
Eth1 (NET 2) IP Address/netmask = 192.168.1.102/255.255.255.0
You may skip this procedure if ANY of the following are true:
• The preconfigured settings work with your existing automation system.
• You would prefer to change the network settings in your automation system.
If you need to change these settings to enable LAN communications or file sharing, follow this procedure.
Note: The username and password required to configure the ContentDepot receivers will be sent to you
via email.
Tools and materials: Any one of the following setups:
• A computer with an Ethernet port and either the supplied cross-over Ethernet cable or a LAN hub or
switch and a regular Ethernet cable; web browser, Internet Explorer
• 5.5 SP2 (or better) or Netscape 7.1 (or better).
• As required, configure the Ethernet ports on the receivers to work with your existing production Local
Area Network (LAN).
To configure the IP addresses of your receiver, use the front-panel controls. See “Controlling the
Receiver with the Front Panel LCD Display/Keypad Interface” in the IDC SFX Pro Audio Series
Satellite Receiver Addendum delivered with the receiver.
Preconditions:
1) You've completed the host addresses worksheet.
2) The green “control” LED on the front panel is flashing steadily.
End condition: The receiver is properly configured and attached to the production LAN.
Procedure 5. Configuring a storage receiver
Step
Instruction
1
As required, configure the Ethernet ports on the receivers to work with your existing production
Local Area Network (LAN).
To configure the IP addresses of your receiver, use the front-panel controls. See “Controlling the
Receiver with the Front Panel LCD Display/Keypad Interface” in the IDC SFX Pro Audio Series
Satellite Receiver Addendum
delivered with the receiver.
2
Click on the SFX Cockpit link.
3
Select Identity to change the IP parameters.
4
Specify the IP address, netmask, and gateway address for this host in the production LAN.
Refer to your host addresses worksheet.
5
Click on the Send Update button to accept your changes.
6
Return to the ContentDepot main menu, and click on the File Sharing link, located beneath
the Receiver Setup heading.
7
Specify the Windows workgroup or domain to match that of your automation system’s
workgroup name. The default here is ContentDepot.
8
Click on the Send Update button to accept your changes.
9
If you used KVM I/O devices or a generic workstation, disconnect the devices.
If you changed the IP address on the workstation, you might need to change the IP address
of the workstation to the previous setting. If you used the automation workstation for this
procedure, and intend to keep this direct LAN connection between the two devices, you are
done.