Prusa i3 Hephestos Settings Manual - Z Axis Settings
Other manuals for i3 Hephestos:
Printing Handbook
of
4
1
Z axis settings
Before commencing the printing process you need to adjust the screw that regulates the height of
the Z axis, so that the extruder is positioned at the correct distance from the bed. To do so, follow
the steps below:
1 Balance the ends of the X axis, using the screw to manually adjust each axis until they
are both at the same height.
2 Tighten the adjustment screw until it extends 4 mm above the printed part.
3 Move the extruder to its starting position by selecting the Control > Move axis > Auto
home options on the LCD control panel.
Note: manually check that all the endstops touch their respective axes.