PS Audio PerfectWave DAC Mk II Upgrade Kit - page 16

Place the DAC Mk II Label

64. Peel the back from the DAC Mk II label and place it on the rear panel of your DAC in the location shown 

below.

Firmware Update

65. Plug your DAC back into the power source.

66. Remove the SD card from your DAC if you have one installed.  Press to eject.  You will no longer need 

this SD card.

67. Insert the SD card with the new firmware that came with your kit into your DAC. The SD card included 

in your kit contains the latest firmware.  

Note: The SD card plugs into the socket upside down with the contacts facing up.

68. Turn the rear panel power switch ON.  The logo button will flash for 40 seconds, the “INITIALIZING” 

screen with the progress bar will show for 55 seconds, the progress bar will remain at its end for 

6 seconds, then the screen will go blank for 10 seconds.  At this point the DAC will initialize to its 

operating state.  Be patient and do not disturb the installation process.

Rear Flange

EMI Gasket Foam

Inside the Chassis

EMI Foam

Press Back

and Down

Place Label here

SD Card up Side Down