PS Audio Power Plant Premier Owner's Reference Manual - page 13
4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.pspower.com
Troubleshooting 9
Troubleshooting
©2007 PS Audio International Inc. All rights reserved.
®
Owner’s Reference
Power Plant Premier
If the trigger circuit is not working, check to make sure you are feeding it proper voltage. The trigger
circuit requires 5 to 15 volts positive. You can test the trigger circuit with a simple 9 volt battery.
Connect the minus of the battery to the outer ring of the trigger input mini jack and the plus to the “tip”
or center of a male mini jack. The 9 volt battery will provide the proper voltage to operate the trigger.
When power is applied, the Power Plant Premier will turn on. When power is removed, the Power
Plant Premier will turn off.
If you experience a hum through the speakers once the Power Plant Premier is powering your
equipment this can be caused by several things. The fi rst is the source. If there is an excessive
amount of buzz or noise from the loudspeaker, it may be caused by a ground loop, a light dimmer in
the home, poor AC power, or any number of causes. The quickest way to determine where to start
your search is to simply turn the preamplifi er, integrated, receiver or Control Amplifi er off, disconnect
the audio cables between it and the sources, and see if the hum goes away when you turn the
preamplifi er, integrated, receiver or Control Amplifi er back on. If it does, it’s most likely a ground loop
or buzz from a dimmer.
If this doesn’t solve the problem, follow these easy humbusting tips.
The easiest way to fi gure out where ground loop problems lie is by the process of elimination. You
need to determine where the hum or buzz is coming from within your system.
If the hum/buzz goes away when you remove the inputs to the power amp, your next step will be
to reconnect the amp and move further down the chain. If you were working with a receiver or an
integrated amplifi er, you will need to jump to step 4. If you have a preamp, or processor that is feeding
the power amp, your next step would be to disconnect all inputs to the preamplifi er or processor. Once
these are disconnected, and the preamp or processor is connected only to the power amplifi er, turn
the system on and again, listen for hum. Should the hum now appear, it is a problem with your preamp
or processor or their interaction with the power amp. Before returning the preamp or processor to
the manufacturer, try a cheater plug to break a ground loop. Cheater plugs are simple devices that
convert a three prong AC plug into a two prong AC plug and in the act of converting three prongs, to
two prongs, they disconnect the ground from the wall socket. Try one of these on the preamp, or the
power amp, or both.
If you determine that there is still no hum present when the preamp, processor or receiver is
connected with no inputs, then selectively begin plugging in your various inputs one at a time. After
each connection, check for hum until you discover the humming culprit.
VCR’s, surround processors, and any device that is connected to a television cable or satellite dish
can cause a loud buzz and should always be suspect. If, by the process of elimination described
above, you determine it is a component like a VCR that is causing the hum/buzz to occur, and using
a cheater plug or removing the ground pin on a PS xStream Power Cable doesn’t help matters, it may
be necessary to isolate the cable connection (CATV) with an isolation transformer. This inexpensive
device is available at most Wal Mart, Radio Shack or department store type outlets and is sometimes
called a ‘matching transformer’. If you have problems fi nding one, call your local cable TV company
If the trigger isn’t
working
If you have hum
It could be the
cable TV