1. DL manuals
  2. PS Engineering
  3. Recording Equipment
  4. PMA8000BTi
  5. Installation and operation manual

PS Engineering PMA8000BTi Installation and operation manual

Manual is about: Audio Selector Panel with Marker Beacon Receiver High-fidelity Stereo Intercom

Summary of PMA8000BTi

  • Page 1

    9800 martel road lenoir city, tn 37772 www.Ps-engineering.Com p p m m a a 8 8 0 0 0 0 0 0 b b t t i i document p/n 200-890-1722 revision 1, march 2016 audio selector panel with marker beacon receiver high-fidelity stereo intercom system installation and operation manual faa- tso c50c, c35d easa etso...

  • Page 2

    Table of contents section i – general information................................................................ 1-1 1.1 introduction............................................................................................................................ 1-1 1.2 scope ..............................

  • Page 3

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-1722 page ii rev. 1, march 2016 2.12.1 r equired t est e quipment ........................................................................................ 2-12 2.12.2 a udio p a...

  • Page 4

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 1-1 rev. 1, march 2016 section i – general information 1.1 introduction the pma8000bti represents another evolutionary step in cockpit audio control and intercommunica...

  • Page 5

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 1-2 rev. 1, march 2016 a 3-light, 75 mhz marker beacon receiver is integrated in the pma8000bti. This provides the necessary marker beacon lights and audio indications...

  • Page 6

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 1-3 rev. 1, march 2016 audio selector specifications audio selector panel input impedance: 510  input isolation: -60 db (min.) speaker muting: -60 db (min.) speaker o...

  • Page 7

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 1-4 rev. 1, march 2016 1.6 equipment supplied 1 ea. Of the following units: model description part number pma8000bti pma8000bt audio panel with intelliaudio, marker, s...

  • Page 8

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-1 rev. 1, march 2016 section ii - installation 2.1 general information 2.1.1 scope this section provides detailed installation and interconnection instructions f...

  • Page 9

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-2 rev. 1, march 2016 2.3.4 audio panel tray and connector assembly the rack connectors mate with two 44-pin connectors in the pma8000bti. The connectors are a su...

  • Page 10

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-3 rev. 1, march 2016 ground connections are made directly to the dedicated music signal and ground inputs on the pma8000bti. The power for ife and audio panel sh...

  • Page 11

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-4 rev. 1, march 2016 some avionics do not provide a separate audio low, and may introduce additional electrical noise into the system. For best results, connect ...

  • Page 12

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-5 rev. 1, march 2016 note inputs 1, 2 and 4 are fixed (1:1), and any audio level adjustments must be made at the input source. Unswitched #3 has a variable adjus...

  • Page 13

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-6 rev. 1, march 2016 fcc regulation 47 cfr § 22.925 prohibition on airborne operation of cellular telephones. Cellular telephones installed in or carried aboard ...

  • Page 14

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-7 rev. 1, march 2016 figure 2-3 jumper locations 4. Place the lid back on the unit, aligning holes. 5. Install and tighten qty. 4 long thread screws into the lid...

  • Page 15

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-8 rev. 1, march 2016 2.4.13 pa mute (j2, pin 12) pin 12 of j2 is a ttl logic output that is active low during ptt operation. 2.4.14 miscellaneous logic output (j...

  • Page 16

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-9 rev. 1, march 2016 2.5.2.1 entertainment 2 mute (j2 pin 13 & 14) connecting j2 pin 13 to pin 14 (or ground) through a spst switch places the entertainment #2 m...

  • Page 17

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-10 rev. 1, march 2016 2.7 adjustments the pma8000bti is factory adjusted to accommodate the typical requirements for most aircraft configura- tions. There are th...

  • Page 18

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-11 rev. 1, march 2016 2.9 pma8000bti pin assignments j1 function j2 function 1 mkr ant 1 pilot phones low 2 mkr ant low 2 copilot phones low 3 telephone audio in...

  • Page 19

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-12 rev. 1, march 2016 2.10 wiring checkout after wiring is complete, verify power is only on pins 8 and 9 of the j2 and airframe ground on connect- or pins 10 an...

  • Page 20

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-13 rev. 1, march 2016 15. Push both the rcv buttons at the same time to activate the intelliaudio™ function. Verify that the audio from com 1 is present in the 1...

  • Page 21

    Ps engineering pma8000bti intelliaudio audio selector panel and intercom system installation and operator’s manual 200-890-17221722 page 2-14 rev. 1, march 2016 cables and coaxial cables. Verify that the cables are not exposed to any sharp edges or rough surfaces, and that all contact points are pro...

  • Page 22

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-1 rev. 1, march 2016 section iii operation 3.1 scope this section provides detailed operating instructions for the ps engineering pma8000bti, audio selector panel/marker beacon r...

  • Page 23

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-2 rev. 1, march 2016 copilot it transmitting, and the pilot presses his ptt, the pilot’s microphone will be heard over the selected com transmitter. In tel mode, the pilot microp...

  • Page 24

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-3 rev. 1, march 2016 3.4 telephone (tel) (9) the tel mode serves as a full duplex interface and distribution for telephone systems such as aircell or portable cellular phones wit...

  • Page 25

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-4 rev. 1, march 2016 adjust the volume level, there is a service adjustment located on the top of the unit. A pushbutton is used to set the receiver sensitivity and to test the i...

  • Page 26

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-5 rev. 1, march 2016 the outer volume control knob controls intercom volume for the passengers. It has no effect on radio or music levels. Adjust the radios and intercom volume f...

  • Page 27

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-6 rev. 1, march 2016 §91.21 “(a) except as provided in paragraph (b) of this section, no person may operate, nor may any opera- tor or pilot in command of an aircraft allow the o...

  • Page 28

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-7 rev. 1, march 2016 crew of aircraft must not be operated while such aircraft are airborne (not touching the ground). When any air- craft leaves the ground, all cellular telepho...

  • Page 29

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-8 rev. 1, march 2016 note the front jack is no substitute for the certified installation of alerts such as the gps waypoint or autopilot tones. These still must be hard wired int...

  • Page 30

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-9 rev. 1, march 2016 3.11.1 “intercom” alternate intercom function (a) this function controls the distribution of aircraft radio within the intercom, as well as passenger interco...

  • Page 31

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-10 rev. 1, march 2016 the pilot can hear this music source in iso mode, if desired, as follows: in the iso mode, hold the (music) button, and press the ics mode button for more t...

  • Page 32

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-11 rev. 1, march 2016 3.12 bluetooth® interface the pma8000bti has a bluetooth interface. The audio panel is always “discoverable,” so you just need to search for the pma8000bt f...

  • Page 33

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-12 rev. 1, march 2016 figure 3-3 playback controls ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 3-12 re...

  • Page 34

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 page 4-1 rev. 1, march 2016 section iv – warranty and service 4.1 warranty in order for the factory warranty to be valid, the installations in a certified aircraft must be accomplished ...

  • Page 35

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 appendix a rev. 1, march 2016 appendix a – external ptt hook up part of the installation includes the installation of ptt (push to talk) switches that allow the use of your aircraft rad...

  • Page 36

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 rev. 1, march 2016 appendix b – pma8000 installation drawings j2 j1 viewed from back 15 30 44 1 16 31 15 30 44 1 16 31 ground lug ground lug 475-440-0001 (x2) back plate assy 475-009-00...

  • Page 37

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 appendix c rev. 1, march 2016 appendix c – j1 connector interconnect com 1 audio hi com 1 mic key com 1 lo communications transceiver #1 communications transceiver #2 nav 1 audio hi nav...

  • Page 38

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 appendix d rev. 1, march 2016 appendix d – j2 connector interconnect 22 20 31 16 1 35 36 24 23 25 4 3 2 copilot phones (r) copilot phones (l) copilot phones lo pass. 1 mic jack pass. Mi...

  • Page 39

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 appendix e rev. 1, march 2016 appendix e – instructions for faa form 337 and continuing air- worthiness 9.1 instructions for faa form 337, audio panels one method of airworthiness appro...

  • Page 40

    Ps engineering pma8000bti audio selector panel and intercom system installation and operator’s manual 200-890-1722 appendix f rev. 1, march 2016 appendix f – rtca do160d environmental qualification form audio selector panel/intercom/marker beacon receiver part number: 050-890-( ) faa tso number: c50...