PSA Products Pinkerton Quick Start Manual - Hd and Analogue
4
Select resolution, fps, encode, quality and bitrate.
When numeric value is higher, recorded video is
clearer, but more memory will be taken up.
Click Next to present HDD management window.
Check HDD information here, if it was installed
recently, select the HDD from the list to format it.
Click
Next to present DVR status, click Finish button
to end Wizard.
You can refer to complete setup steps from the
relevant section of DVR User Manual. If you don't
want to setting Wizard, please click Exit.
If you wish to use both AHD and analogue cameras
on this DVR you will need to change the resolution
settings as follows:
Login
After exitting Wizard Setting, you can login to DVR.
Click shortcut menu button, a Login dialogue box is
presented
User Name: admin
Changing Display Resolution
Optimize DVR Video output to match with monitor
output as following steps:
Note:Make sure the monitor supports same
resolution as your DVR output resolution, otherwise,
the monitor is unable to display video.
STEP 1. Get into Main Menu from desktop shortcut
menu
STEP 2. Click Setup, then choose Basic menu
STEP 3. Select the desired resolution from Video
Output
STEP 4. Click Apply to save settings
STEP 5. Click Exit to restart system, and then re-
login afterwards
No Password
HD AND ANALOGUE
CAMERA SETTINGS
E
HD CAMERAS
SET TO 720P
ANALOGUE CAMERAS
SET TO 960H
THIS WILL SET CHANNELS IN PAIRS, i.e. (1 and
2)( 3 and 4)( 5 and 6 )( 7 and 8). You can not mix
the camera type in each pair.
Note: Above Setting is only applicable to Analogue
HD DVR