Q Digital 1A-QP686 Installation And Operation Manual - page 15
12
A
L
M
-
4
A
L
M
-
3
A
L
M
-
2
A
L
M
-
1
G
N
D
C
O
M
N
C
N
O
Alarm input
ALM-1
ALM-2
ALM-3
ALM-4
Alarm output
No.1-channel alarm was activation, then call No.29 preset
No.2-channel alarm was activation, then call No.30 preset
D3
No.3-channel alarm was activation, then call No.31 preset
No.4-channel alarm was activation, then call No.32 preset
Presetting the preset of NO.29
30
31
32,
then the alarm could respond.
Figure 15-2
11) Based on the coding switches shown as Figure 2, set up the protocol used by the
camera and the baud rate as per the state according to Table 2. Check the address of
the camera to see if it is matched with that you need. If not, set the address of the
dome camera at corresponding position as per Table 1.
12) Rotate the vitreous cover on dome counterclockwise and take it out. Note: if
Fixed the Speed Dome Camera in the aluminum alloy ball, you must take out the
vitreous cover on dome. Otherwise, it will effect picture quality. (see Figure 16)
13) Aiming the “MARK” on the ball at the notch on the pedestal, push the ball upward to
the end and rotate clockwise until it is clicked, then mount the vitreous cover by
rotating it clockwise (as shown on Figure 17), and mount the cover plate of the
bracket at last (see Figure 18).
OPEN
CLOSE
Figure 16
Mark
OPEN
CLOSE
Figure 18
Figure 17
3. Steps of Installation for Indoor Ceiling Style
1) Install the pedestal on the base plate (as shown on Figure 19).