Q-See QD7015P User Manual - page 11
11
MOUNTING THE CAMERA
STEP 1. Run the power/video/data extension
cable from the DVR to the camera’s
location.
STEP 2. Usethemountingbrackettomark
the position for the mounting holes.
Drill the mounting holes with a 3/16”
(5mm) drill bit. If needed, the hole for
the cables should also be drilled at this
time. It is best to drill a large enough
hole to prevent the cable from catching
on anything and allowing the cable
extending from the camera to be easily
pushed through.
STEP 3. Remove the bottom plate from
the bracket’s arm to make threading
the cables easier. Pass the ends of the
extention cable through the hole in the
back of the bracket.
STEP 4. Insert the included anchors into
the mounting holes, and mount the
bracket to the surface.
STEP 5. Pass the cable ends from the
camera through the hole at the front of
the bracket (the green block should be
passed through the hole first).
STEP 6. Connectthecamera’scableendsto
those on the extention cable.
STEP 7. Secure the camera to the mount
using the three short bolts.
STEP 8. Make sure that the cables aren’t
crimped inside the bracket arm and
replace the bottom plate, securing it
with the screws. If needed, push excess
cable back into the wall.
IMPORTANT!
Do not allow the
camera cable to be subject to
pinching, tight bends or other severe
constriction as part of its final installation position
as this can damage the cable over time leading to
signallossorpotentialfirehazard.
Take precautions to ensure a clear work area below
the camera mounting point during installation as a
falling camera can cause injury or damage.