Q-See QSTC201 Quick Installation Manual

Other manuals for QSTC201: User Manual, Quick Start Manual

Manual is about: Q-See - Digital Peripheral Solutions Security Camera User Manual

Page of 4

Download

Bookmark us

Q-SEE IP CAMERA MODEL QSTC201/211 QUICK INSTALLATION GUIDE

1. Connection Diagram

a. Connect the Q-See IP camera to the same Router as your PC.

2. Setting up the Connection on a PC

a. Find the IP address of the PC: To do this:

Go to Start – Run (XP) and type CMD. In Vista, type CMD in Search. You will get the Command prompt

screen. Type in “IPCONFIG”. Note the IP Address, Subnet Mask Address and Default Gateway Address

listed on your command screen and write these down for future reference. See example below (Figure

1).

(Figure 1)

*Note the IP Address for this example is 192.168.0.105,

the Subnet Mask is 255.255.255.0 and the Default Gateway is 192.168.0.1

b. Insert the installation CD for the Q-See IP camera and Install the Q-See IP Camera as prompted by the

pop-up menu that appears on your screen.

c. Once the Q-See IP Camera Software is installed:

Go to: Start-All Programs-ControlCenter-IPTOOL. You will see a dialog box listing all connected IP

Cameras with the appropriate Addresses listed. See example below (Figure 2).

(Figure 2)

*Note that the example of this IPTOOL screen above lists an IP Camera with the Device Name of “name”,

an IP Address of 192.168.1.201, a Subnet Mask of 255.255.255.0 and a Gateway of 192.168.1.1

Page 1
Q-see ip camera model qstc201/211 quick installation guide 1. Connection diagram a. Connect the q-see ip camera to the same router as your pc. 2. Setting up the connection on a pc a. Find the ip address of the pc: to do this: go to start – run (xp) and type cmd. In vista, type cmd in search. You wil...
Page 2
D. If the ip address, subnet mask and gateway address listed in the iptool dialog box is different than those listed in your command screen (see figure 1), then the iptool addresses and subnet mask must be changed accordingly. To do this, right click on the name of the device with the addresses you ...
Page 3
(figure 6) 3. Setting up the wireless function of the camera a. In your internet explorer browser window (see figure 7), click on the “system config” button on the bottom right hand side of your screen. B. A menu box will appear (see figure 7). In this menu box, choose the “wireless config” option n...
Page 4
I. If your router is encrypted, then you will need to set all the addresses manually with the addresses listed on your iptool screen (see figure 4). To do this, check the “use the following ip address” box on your menu box (figure 7) and enter the information manually. E. Once you have completed the...