Q-Tech QP031 Owner's Manual - page 6
6
Contact with aluminum parts may cause an
explosion.
Some of the most common of these solvents
are: Carbontetrachloride, Chlorobenzene,
Dichloroethane, Dichloroethyl Ether,
Ethylbromide, Ethylchloride, &
Tethrachloethane.
PREVENT STATIC SPARKING FIRE/EXPLOSIONS
Vapors created when spraying can be
ignited by sparks.
To reduce the risk of fire, always locate the
sprayer at least 20 feet (6 m.) away from
spray area. Do not plug in or unplug any
electrical cords in the spray area. Doing
so can cause sparks which can ignite any
vapors still in the air. Follow the coating &
solvent manufacturers safety warnings and
precautions.
MEDICAL ALERT - Airless Spray Injection
Injuries
If any fluid appears to penetrate your skin,
GET EMERGENCY MEDICAL CARE AT ONCE.
DO NOT TREAT AS AN ORDINARY CUT.
High pressure fluids from spray or leaks are
powerful enough to easily penetrate the skin
and cause extremely serious injection injury,
leading to the possible need for amputation.
•
NEVER
point the spray gun at anyone or
any part of the body.
•
NEVER
put your hand or fingers over
the spray tip. Do not use a rag or any
other materials over your fingers. Paint
will penetrate through these materials &
into the hand.
•
NEVER
try to stop or deflect leaks with
your hand or body.
•
ALWAYS
have the tip guard in place
when spraying.
•
ALWAYS
lock the gun trigger when you
stop spraying.
•
ALWAYS
remove tip from the gun to
clean it.
•
NEVER
try to "blow back" paint, this is
not an air powered sprayer.
•
ALWAYS
follow the
PRESSURE RELIEF
P R O C E D U R E
b e f o r e c l e a n i n g o r
removing the spray tip or servicing any
system equipment.
•
Be sure the equipment safety devices
are operating properly before each
use.
•
Tighten all of the fluid connections
before each use.
•
NEVER
alter equipment in any manner.
•
NEVER
smoke while in spraying area.
•
NEVER
spray highly flammable materials.
•
NEVER
use around children.
•
NEVER
allow another person to use
sprayer unless he is thoroughly instructed
on its safe use and given this operator’s
manual to read.
•
ALWAYS
wear a spray mask, gloves and
protective eye wear while spraying.
•
ALWAYS ensure fire extinguishing
equipment is readily available and
properly maintained.
NEVER LEAVE SPRAYER UNATTENDED WITH
PRESSURE IN THE SYSTEM. FOLLOW PRESSURE
RELIEF PROCEDURES