Q4 Audio DPI 10 User Manual - page 12
DPI SERIES USER MANUAL
Model
DPI10 DPI15 DPI20 DPI30 DPI40
Min. output power per channel into 2 ohms
500 W
900 W 200 W 600 W 2200 W
1 kHz sine wave, THD
Min. output power per channel into 4 ohms
300 W
500 W
800 W 00 W 500 W
1 kHz sine wave, THD
Min. output power per channel into 8 ohms
200 W
330 W
450 W
600 W
800 W
1 kHz sine wave, THD
Min. output power in bridge mode into 4 ohms
000 W 800W 2400 W 3200 W 4400 W
1 kHz sine wave, THD
Min. output power in bridge mode into 8 ohms
600 W 000 W 600 W 2200 W 3000 W
1 kHz sine wave, THD
Typical THD+N
1 KHz -3dB output power
SMPTE intermodulation distortion
60 Hz - 7 KHz 4:1 at -3dB output power
Dynamic intermodulation distortion
30 KHz bandwidth at -3dB output power
Frequency range
+ 0 dB / - 0.8 dB
20 Hz - 20 kHz at nom. output power
Small Signal Frequency response
5 Hz - 50 kHz
-3dB; Load impedance 2 - 6 Ohms
Large Signal Bandwidth
35 kHz
Rise time
Damping factor
> 3000 (EFL used)
1 KHz referred to 8 ohms
Voltage gain
+36 dB
Level controls full cw
Noise interference
22 Hz - 22 KHz rms A weighted, referred to nom. output power
Crosstalk
1 KHz / 8 ohms
Input CMRR
> 80 dB
100 Hz
Output DC offset voltage
Input impedance
0 Kohms unbalanced / 20 Kohms balanced
Input connectors
/4” phone jack / XLR compound receptacle, parallel XLR male
parallelled Phoenix® screw terminals
Output connectors
x 4-pole Speakon per channel / x 4-pole Speakon for bridge
parallelled Phoenix® 4 mm² screw terminals
Cooling
Forced cooling with 2 vari-speed fans / front to rear airflow
Mains supply
115 V / 230 V ±10% AC 50/60 Hz
Dimensions
Width: 482 mm, Height: 88.9 mm, Depth: 350 mm
(mounting base to connector panel)
Net weight
3.5 kg
5 kg
6 kg
8 kg
20 kg
Shipping weight
6.3 kg
8 kg
9 kg
2 kg
23 kg
Standards
Safety: EN60065 EMC: EN5503-/EN5503/2/E2/E3
Note: Distortion measurements with AES-17 low pass filter.
8. Specifications