QAcoustics Q M4 User Manual - page 13
PAIRING A
BLUETOOTH
DEVICE
The unit is designed to automatically go into pairing mode if there is no
Bluetooth
device connected. To Pair
your
Bluetooth
source:
1. Turn the unit and the
Bluetooth
device ON.
2. Make sure
Bluetooth
is enabled on the device to be Paired. The
Bluetooth
controls are typically found
in the device’s ‘Settings’ or ‘Connections’ menu.
3. On your device’s list of discoverable devices, you should now see ‘Q M4-XXX’ where XXX is a pre-de
fi
ned
three digit number.
(Refer to Rear Panel section for the Bluetooth name label.)
4. Select ‘Q M4-XXX’ and your device will now be Paired via
Bluetooth
and Connected.
5. From within the music player on your device, select ‘Q M4-XXX’ as the audio output and press Play. Unless
the remote has been used to manually select another source and override Auto-Source Selection, the
unit will switch to
Bluetooth
input and the LED will turn Blue.
PAIRING A BLUETOOTH DEVICE WITH NFC
1. Turn the unit and the Bluetooth NFC device ON.
2. Make sure Bluetooth and NFC are enabled in the device settings.
3. Place NFC device on the top surface of the unit, in the location indicated.
4. The NFC device will automatically register on screen when an NFC connection has been made.
5. Follow on-screen instructions to complete NFC pairing. This usually involves selecting to allow NFC
pairing.
6. Your device will now be paired, and connected via Bluetooth, and will function as any other Bluetooth
source when pressing play from within the device music player.
Please Note:
Although starting to Play a track on the connected source will cause the unit to switch to
Bluetooth
, the unit will stay on
Bluetooth
until the source is disconnected. It will not switch to another source whilst the player is paused.
Please Note:
You may need to rotate your device for NFC to connect, as NFC coil is in di
ff
erent locations within di
ff
erent devices.
Please see your device instruction manual for correct NFC operation.
The distance for NFC pairing occurs vary from device to device.
16
SOURCE VOLUME CONTROL
Audio sources will initially be set at a DEFAULT volume level. The volume can be adjusted separately for
each source using the VOL + and VOL – buttons on the top panel or IR remote. Once adjusted, the unit will
remember the new volume level for the currently selected source, and will return to that level each time
that source is re-selected.
Instructions
NFC Pairing Position
120 mm
75 mm