Qindao Hichanse Group ALZ513 Assembly Instructions Manual - page 6
*If you have opened the carton and removed all packages, please disregard the STEP 1 and 2. See the STEP 3 directly.
* Please keep these assembly instructions for future reference.
ASSEMBLY INSTRUCTIONS
3) place fake wood in the flre bowl on the top of the flre
pit.
** DO NOT COVER THE IGNITION SCREEN when placing the fake wood into the fire bowl. Always keep Ignition Screen visible. * *See
below WARNING and Figure .
2) Screw Regulator Coupling clockwise by hand only. Make
sure it is fastened.
STEP 3.
(I) Check each part before using the product. Make sure the
gas supply system is turned "OFF" before assembling.
(II) Put the gas tank on the metal stand. Make sure the gas
tank sits on the metal stand completely. Turn the wing screw
on the outer part of metal stand clockwise to secure the gas
tank tightly.
(III) Make sure the hose is secured in retainer clip. Connect
the Pressure-Regulating Valve to the gas tank.(See Figure
IV.)
1) Turn the T-handle clockwise to close the gas supply on the
gas tank.
STEP 1.(1) Open the carton and turn it upside down, make sure the 4 flaps of the carton being open up as below FigureSTEP 1. (2) Lift
off the carton carefully and be wary of the accessories inside falling away.Take away one box containing the fake wood (3) Take all the
packing materials away except for the polyfoam rounding the top of the firepit, See Figure STEP 1.
STEP 2. (1)
Turn the firepit heads up on a flat ground.
(2) Cut off the binding tape on the polyfoam
and remove all the polyfoam rounding the
top of the firepit.
(3) Cut off the tie fastened the regulator at
the metal stand and set it free for
installation to LP-Gas Tank.
See Figure STEP 2.
STEP 3
Ⅲ
Ⅰ
ⅠⅠ
STEP 2
STEP 1
6