QMS 4060 Accessories Manual

®

Caution: We highly recommend that you have an authorized QMS service technician install your QMS 4060 as well 

as the optional large-capacity input feeder and the 3000-sheet large-capacity output stacker. However, if you do 

install these options yourself (or if you ever move the printer and these options), you must make certain that the 

option aligns correctly with the printer.

This document provides quick installation information for both the large-capacity input feeder and the 3000-sheet large-capacity output 

stacker.  For complete information, refer to chapter 6, “Hardware Options,” in the Options manual (on the 4060 Documentation  

CD-ROM).

Unpack all items 

from the box.

Save the packing 

material for 

possible 

repacking.

Locate the 

support stand, 

the support stand 

guide, and the 

sheet guide.

Open the front 

door of the 

printer.

Using a Phillips 

screwdriver, 

remove the right 

side paper input 

cover by 

loosening the 

front screw and 

removing the rear 

screw.

Attach the sheet 

guide to the 

printer using the 

screws you 

loosened and 

removed earlier.

Install the 

support stand 

guide using the 

screws attached.

Lift the support 

stand and place it 

on top of the 

support stand 

guide.

Attach the 

support stand to 

the support stand 

guide.

Pull out the 

support stand 

slide-rails until 

they lock in the 

out position.

Set the LCIF on 

the pins of the 

slide-rail.

Secure the LCIF 

to the support 

stand using the 

thumbscrews.

Slide the LCIF 

into the sheet 

guide on the 

printer until it 

locks in place.

Caution: 

Adjust the 

leveling feet 

on the 

support 

stand so that 

the leveling 

chains are 

just touching 

the floor.

Make sure the 

power on the 

printer is turned 

off.

Press the release 

handle on the top 

of the LCIF, and 

pull it away from 

the printer.

Connect the 

interface cable to 

the connector on 

the rear lower-left 

side of the 

printer.

Slide the LCIF 

into the sheet 

guide on the 

printer until it 

locks in place.

1

2

3

..

........

..

......

4

5

6

LTR

LTR

LTR

7

Note: Refer to Chapter 6, “Hardware Options,” of the

Options manual (on the 4060 Documentation

CD-ROM) for instructions on using the LCIF.

8

!