QMS Magicolor 2 Desklaser Supplementary Manual

Introduction

These repacking instructions are designed for QMS 

magicolor 2 Print Systems 

damaged in transit and being returned to QMS, Inc.

»

Note: 

It’s very important that you repack the print system in its original shipping carton 

before using the instructions in this document. This is necessary so QMS can deter-

mine the cause of the shipping carton failure and remedy this problem in future ship-

ments. (Refer to chapter 9, “Repacking the Printer,” in the QMS magicolor 2 Print 

System Operation

 manual for instructions on repacking the printer in its original shipping 

carton.) 

Procedure

Once you’ve repacked the printer in its original shipping 

carton, use these instructions to pack it in its special 

overpack carton.

1

Assemble the overpack carton, closing and 

taping the bottom flaps.

2

Set the carton on a flat surface. 

3

Place at least 4" of polystyrene packing 

material (“peanuts”) on the bottom of the 

carton.

If you don’t have any polystyrene packing 

material, you can purchase some from a local mailing or shipping company.

4

Set the printer, in its original shipping carton, on the polystyrene packing 

material in the center of the overpack carton.

5

Fill the rest of the overpack carton with packing material, surrounding the 

original shipping carton on all sides and the top.

6

Close and tape the top flaps of the overpack carton.

7

Attach the shipping symbol labels to the top-left corner of all four sides of the 

overpack carton.

8

Complete and attach the shipping label to one side of the overpack carton.

9

Send the carton back to QMS, Inc., One Magnum Pass, Mobile, AL 36618.

P/N 1760198-001A

QMS

®

 magicolor

®

 2 Print System

Special Repacking Instructions

QMS and magicolor are registered trademarks of QMS, Inc.  All other trademarks of the property 

of their respective owners. Copyrighted  © 1997 by QMS, Inc. All Rights Reserved.