Qpcom QP-WA354AG User Manual - Auto
15
rate for transmission. Select the basic rates to be used among
the following options: Auto, 1, 2, 5.5, 11or 54 Mbps. For
most networks the default setting is
Auto
which is the best
choice. When
Auto
is enabled the transmission rate will
select the optimal rate. If obstacles or interference are
present, the system will automatically fall back to a lower
rate.
Preamble Type
A preamble is a signal used in wireless environment to
synchronize the transmitting timing including
Synchronization and Start frame delimiter. In a “noisy”
network environment, the Preamble Type should be set to
Long Preamble
. The
Short Preamble
is intended for
applications where minimum overhead and maximum
performance is desired. If in a “noisy” network environment,
the performance will be decreased.
Hide SSID
Select
enabled
to allow all the wireless stations to hide the
SSID of this router.
Tx Burst
Select the check box to enable the Tx Burst function.
802.11g Protection
The 802.11g standard includes a protection mechanism to ensure
mixed 802.11b and 802.11g operations. If there is no such kind of
mechanism exists, the two kinds of standards may mutually
interfere and decrease network’s performance.
AckTimeOut
Maximum time, in microseconds, that the failover daemon
will wait for an ACK or NOACK message to be received
from the peer failover daemon. For each message the
failover daemon sends, the peer failover daemon sends an
ACK or NOACK message to indicate that the peer is still
functioning.
Default:
50
microseconds
Apply Change
Press to save the new settings on the screen.
Reset
Press to discard the data you have entered since last time
you press Apply Change.
Security
Here you can configure the security of your wireless network. Selecting different method
will enable you to have different level of security. Please note that by using any
encryption, by which data packet is encrypted before transmission to prevent data packets
from being eavesdropped by unrelated people, there may be a significant degradation of
the data throughput on the wireless link.