Qtx PAV8-UHF User Manual - page 7
178.859UK User Manual
Bluetooth Receiver
The final mode for the media player is as a Bluetooth receiver. This allows pairing with a smart
phone or tablet for wireless playback of audio from the device.
Enable Bluetooth on the sending device and scan for Bluetooth devices.
Check for a device called “PA SYS”
Select this device and opt to connect to it.
Your sending device should state that it is connected to “PA SYS” for audio output.
Play audio on the sending device and check for output through the PAV8-UHF speakers.
The PAV8-UHF Bluetooth receiver has duplex Play/Pause control over the sending device.
Press the transport (Previous, Next, Play/Pause) buttons on the rear panel to control the
playback on the sending device. This is useful when the audio is played from a phone in a
pocket or on an armband or from a PC or Mac computer.
Remote Control
The output level of the media player is adjusted via the main Volume control (15)
Alternatively, the media player can be operated using the infra-red remote handset.
This offers some extra functions, which are detailed below.
1. Eject
2. Power on/off
3. Previous track
4. Switch between USB/SD media
5. Volume down
6. Mute output
7. * not used
8. * not used
9. On-screen display: LEFT key
10. Numerical select: +10
11. Numerical select: 0-9
12. Mode select key
13. Play/Pause
14. Next track
15. Repeat mode
16. Volume up
17. DVD audio output: L, R or L+R
18. On-screen display: UP key
19. On-screen display select
20. On-screen display: ENTER key
21. On-screen display: RIGHT key
22. On-screen display: DOWN key
23. On-screen display: ESCAPE key