Qtx QX10BT User Manual - page 3
QXBT User Manual
Controls
Operation
Connect any line input (CD, mp3 player, home keyboard etc.) to the QXBT speaker via the 6.3mm jack line
input (12) or alternatively, connect a microphone to the XLR mic input (11)
Turn the VOLUME control (7) fully down and turn the POWER switch (3) on. BASS and TREBLE controls
(8, 9) should remain pointing vertically (12-o-clock position).
Turn up the VOLUME control part way and test the input signal (line or microphone) for output through
the speaker. Adjust the VOLUME to the required output level and TREBLE and BASS controls to adjust the
overall tone of the output (clockwise to boost, anti-clockwise to cut).
Bluetooth™ Connection
QXBT units are fitted with a Bluetooth receiver, which is operated via a rotary control (4) and play button
(5) on the rear panel. When the rotary control is turned fully off, power to the Bluetooth receiver is off.
If switched off, turn the Bluetooth rotary control clockwise to switch power on to the Bluetooth receiver.
Turning the rotary control up increases Bluetooth output level – halfway is a reasonable position to start.
Press and hold the Bluetooth play button for 3 seconds and the Bluetooth indicator (6) will flash blue. If
the playback source is already paired, the connection will be made with the QXBT speaker and a chime will
sound to confirm this.
If not paired, press the play button briefly again to see the LED flash between blue and red.
At this point, the Bluetooth receiver is made visible to all Bluetooth devices in range.
Scan for Bluetooth devices on your playback source and check for a device called “bluetooth” (lower case).
Select this device and opt to connect and your sending device should state that it is connected to
“bluetooth” for audio output and the LED should flash blue and a beep will confirm the pairing.
Play audio from your sending device and check for output through the QXBT speaker.
1. Fig.8 mains inlet
5. Bluetooth play button
9. Bass EQ control
2. Mains fuse holder
6. Bluetooth indicator
10. Line output XLRM
3. Power on/off switch
7. Volume control
11. Mic input XLRF
4. Bluetooth off/volume
8. Treble EQ control
12. Line input 6.3mm jack