Quackenbush 158/15QRA Service Manual - Quackenbush
Page 3
PL92-5000EN
05/14/2012
Language Version:
This Parts Manual is the “Original Instructions”
intended for all persons who will use or repair these
tools.
Product Identification:
Refer to the “Model Nomenclature” page in this
document.
Noise and Vibration:
Refer to documents CE-1009DC and CE-1009TD.
General Description:
Air powered right angle adaptive positive feed drill.
Intended Use:
These air powered adaptive feed drills are intended for
drilling holes. Use only for their designated purpose. Do
not use as a hammer, lever or other improper usage that
can cause tool damage and operator injury.
Copyright protection:
Apex Tool Group, LLC reserves the right to modify,
supplement or improve this document or the product
without prior notice. This document may not be reproduced
in any way, shape or form, in full or parts thereof, or
copied to another natural or machine readable language
or to a data carrier, whether electronic, mechanical,
optical or otherwise without the express permission of
Apex Tool Group, LLC.
General Safety Instructions:
These safety instructions must be accessible to the
operator at all times. They must be shown and made
available to all personnel involved in the use of this
equipment.
These safety instructions are not intended to be all
inclusive. Study and comply with all applicable Federal,
State and Local Regulations. If necessary, contact your
local Apex Tool Group representative for assistance.
Always disconnect the tool from the air supply before
adjusting or repairing.
Immediately shut off the tool in the case of unusual
sound or vibration. Have a qualified person check the
tool and repair before using.
Do not modify the tool, any guard or accessory unless
approved in writing by Apex Tool Group.
Implement and follow a Safety Maintenance Program to
provide inspection and maintenance of all phases of tool
operation and air supply equipment.
Eye Protection:
Hearing Protection:
Hearing protection is recommended in high noise areas,
85 dBA or greater. The operation of other tools and
equipment in the area, reflective surfaces, process noises
and resonant structures can substantially contribute to
and increase the noise level in the area.
General Protection:
Follow good machine shop practices. Rotating shafts
and moving components can entangle or entrap and
may result in serious personal injuries. Never wear long
hair, loose fitting clothes, gloves, ties or jewelry when
working with or near a drill of any type.
Quackenbush
®
General Information and Safety
Impact resistant eye protection
must be worn when operating or
working near this tool.
Personal hearing protection is
recommended when operating or
working near this tool.
Do not wear loose fitting clothes,
long hair, gloves, ties or jewelry when
operating or working near this tool.