Quad Electroacoustics L-ite Series User Manual - page 13
21
4
Points to Remember
Unpacking the Lite- Satellites and Centre
Unpacking the Lite- Subwoofer
2
2
It may need two people to lift and manoeuvre the loudspeakers into position. If you cannot manage the task unaided,
enlist the help of a friend.
Always use the supplied cotton gloves when handling exposed surfaces.
Remove the top packing. Lift the loudspeakers from the packaging. Do NOT lift the loudspeakers with the protective
bag - support the loudspeaker properly.
Remove the polythene sleeve.
The loudspeakers need no special adjustments after unpacking and are ready for use.
Refer to Page 11 for full details of unpacking and preparation.
Please retain the packing materials for future use or return them to your dealer. If you decide not to keep the packing,
please dispose of it having regard to any recycling regulations in force in your area.
Please retain the user manual and the information concerning the date and place of purchase of this equipment for
future reference. In the unlikely event that you pass this product on to a third party, please include all the accessories
and this instruction manual.
Before you unpack the loudspeakers, ensure that you have a large and completely clear area of floor on which to
work. Remove or protect any fragile carpets, etc to avoid any damage.
Retain your User Manual!
Retention & Disposal of Packing Materials
Unpacking Your Loudspeakers
L-ite Series
2
L-ite Series
2
Troubleshooting
If your system is not working properly please work through this checklist before returning a unit to your dealer. Before
investigating a problem, always switch off the system at the mains.
Television picture colour is
distorted
Subwoofer too close to TV. (Switch off system and TV. Move units away. Leave
15 mins. Switch on)
Excessive bass distortion at
low volumes
Subwoofer level set too high; LFE level set too high; Subwoofer incorrectly
wired
Excessive or distorted bass at
high levels
System level set too high; Bass control set too high;
Speakers too close to room corners
Popping or thumping from the
subwoofer
System level set high; Subwoofer level set too high; LFE level set too high
Indistinct sound;
Poor localisation of effects.
Poor localisation of dialogue
One or more loudspeakers is out of phase
(Read the manual for correct connection procedure)
Distorted or rattling sounds at
high levels
System level too high; Objects on speakers/subwoofer; Objects too close to
subwoofer; Unstable/loose flooring below subwoofer
Sound lacks bass content
Bass reproduction indistinct
Front loudspeakers out of phase.
Subwoofer not switched on; Subwoofer phase incorrect; Subwoofer
crossover control too low; Incorrect preset; Subwoofer drive unit obstructed
No Sound
System not switched on; Speaker cables shorting terminals out;
Wrong source selected
Symptom
Possible Cause