QUAD EZ-4000 Owners and installation manual - page 3
- 3 -
CAUTION
An improperly installed and/or adjusted Automatic Door can cause injury and
equipment damage.
Door must be installed and adjusted as described in this Owner’s Manual by a
certified professional.
All required safety devices must be in place and operational.
Door must be inspected DAILY. If the door is not functioning correctly it must be
taken out of Automatic Service immediately until a Certified Technician inspects
and repairs the unit.
DO NOT ATTEMPT TO ADJUST OR REPAIR THE DOOR YOURSELF
CALL YOUR AUTOMATIC DOOR SUPPLIER FOR REPAIRS
To our Customers
The purpose of the manual is to familiarize you with your automatic door system. It is essential that
you know your system and that you recognize the importance of maintaining your door system in
compliance with the industry standards for safety.
It is your responsibility, as owner or caretaker of the equipment, to inspect the operation of your
door system on a daily basis, and after any loss of electrical power, to ensure that it is safe for use
by your invitees, customers, or employees.
Daily Safety Checks are the responsibility of the equipment owner or caretaker. The Following
safety checks are to be done daily and/or after any electrical power outages:
1.
When actuated, the door should slowly open at a smooth pace (5 seconds min.) until gently
stopping at the pre-set full open position.
2.
The door should hold open for the pre-set time of not less than 5 seconds
3.
The door should then slowly close at a smooth pace (5 seconds min.) and stop gently.
4.
Make sure the traffic path and threshold area are clean and clear inside and outside of
doorway
5.
Inspect the door, safety decals, connecting arms, hardware and glass for wear or damage.