1. DL manuals
  2. QuadQuestions
  3. Quadcopters
  4. QQ190 FALCON
  5. User Manual

QuadQuestions QQ190 FALCON User Manual

Other manuals for QQ190 FALCON: User Manual
Manual is about: racing drone

Summary of QQ190 FALCON

  • Page 1

    Manual thank you for purchasing the qq190 falcon racing quadcopter and welcome to the qq190 team. This manual details how to physically assemble the frame. There is a diverse array of electrical components that can be used with quadcopter frames, an example set is included in this document and furth...

  • Page 2

    Hardware sizing scale please print this page on 8.5”x11” paper and use the scale to identify the kit parts. ©2016 quadquestions llc. Page 2 patent pending.

  • Page 3

    In addition to the hardware scale part quantities, you should also have included with your kit: a. Main qq190 plate b. Left side fpv hanger c. Right side fpv hanger d. Mid- frame plate e. Battery strap f. Battery protector and landing gear (color might vary from that pictured) g. 5-in-1 power distri...

  • Page 4: Tools Required

    Tools required soldering iron 6-in-one screwdriver solder heat shrink additional parts recommended to complete build basic components 4x motors such as cobra 2300kv for 5” configurations 4x escs such as dys blheli sn20s or kiss 18a escs (or lumenier 20a with bec included) 1x flight controller, such ...

  • Page 5

    Step 1- assemble camera hinge a. Remove camera bracket if installed. B. Install the screws and washers provided into your video camera. Make sure to use 3 washers on each side of the camera. This is to ensure that the screw does not penetrate too far into the camera, and doesn't damage the internal ...

  • Page 6: Hanger

    Step 2. Assemble fpv camera hanger install the camera in between the 2 fpv hangar plates with the camera hinge screws inserted into the hole in the fpv hangar plates. Connect the plates with 2 m3x29mm standoffs. ©2016 quadquestions llc. Page 6 patent pending.

  • Page 7

    Complete your assembly by installing 2 m3x29mm standoff in the adjustable half-precent slot. This is how you will adjust your camera angle. With this configuration, you can adjust the camera angle up to 30 degrees positive or 20 degrees negative. ©2016 quadquestions llc. Page 7 patent pending.

  • Page 8

    Step 3- attach the fpv camera assembly to the mid-frame plate. Use the locknuts provided to hold the gimbal plate to the top plate. ©2016 quadquestions llc. Page 8 patent pending.

  • Page 9

    Step 4- install main standoffs battery strap & electronics it is at this time that we recommend installing your flight controller, battery strap, pdb, escs and motors. We have a multitude of resources for you to get started at quadquestions.Com including a questions and answers section of the site a...

  • Page 10: And Finalize.

    Step 5- install main fpv hanger and finalize. After electronics have been installed, install the fpv camera assembly and finish wiring setup. Finalize your qq190 falcon by installing the battery protector/landing gear f. On to the battery strap. Have fun flying and please brand your videos (logos ca...

  • Page 11

    ©2016 quadquestions llc. Page 11 patent pending.

  • Page 12

    ©2016 quadquestions llc. Page 12 patent pending.