QuadQuestions QQ190 FALCON User Manual - Tools Required
Tools Required
Soldering Iron
6-in-one screwdriver
Solder
Heat Shrink
Additional Parts recommended to complete build
BASIC COMPONENTS
4X motors such as Cobra 2300KV for 5” configurations
4X Escs Such as DYS BLheli Sn20s or Kiss 18a ESCs (or Lumenier 20A with BEC included)
1X flight controller, Such as a Naze32,Openpilot CC3D, SP3Racing, or other
5” Propellers CW/CCW -We recommend high quality propellers such as HQ Prop or ATG for
racing and Dal Prop 5040 for bashing
Radio and receiver such as An FrSky Taranis and a D4R-II
Appropriate to battery supply AWG wire for XT-60 connector, along with other wire for
providing power to additional components.
FPV GEAR:
LC Power Filter (already included if using an OSDoge)
Video transmitter Such as a TS58500 (please be aware of national laws)
HS1177 or equivalent camera (must match this form factor)
OSD such as an OSDoge or Minim OSD
Cloverleaf antenna such as a pair of VAS Bluebeams, Spironets, or TBS triumph
All parts can be obtained at QuadQuestions.com and if you have questions about what parts to
use, please contact us, we are happy to help!
YOU SHOULD PLAN A FEW HOURS FOR YOUR BUILD, A QUAD BUILD CAN TAKE QUITE A BIT OF
TIME TO GET RIGHT, SO TRY NOT TO RUSH THROUGH IT!
©2016 QuadQuestions LLC.
Page 4
Patent Pending