Quadra-Fire HUDBAY-FS Owner's Manual - page 11
11
Quadra-Fire • Hudson Bay • 3-90-7003998_R25 • 07/17
B. Maintenance Tasks - Homeowner
The following tasks may be performed annually by the
homeowner. If you are uncomfortable performing any
of the listed tasks, please call your dealer for a service
appointment.
More frequent cleaning may be required due to lint from
carpeting or other factors. Control compartment, burner and
circulating air passageway of the stove must be kept clean.
CAUTION! Risk of Burns! The stove should be turned off
and cooled before servicing.
Glass Cleaning
Frequency: Seasonally
By: Homeowner
Tools Needed: Protective gloves, glass cleaner, drop cloth
and a stable work surface.
CAUTION! Handle glass assembly with care.
Any safety screen or guard removed for servicing must be
replaced prior to operating the stove.
Installation and repair should be done by a qualified service
technician only. The stove should be inspected before use and
at least annually by a professional service person.
4
Maintenance and Service
Task
Frequency
To be completed by
Glass Cleaning
Seasonally
Homeowner
Remote Control
Seasonally
Venting
Seasonally
Gasket Seal
and Glass
Inspection
Annually
Qualified Service
Technician
Log Inspection
Annually
Firebox
Inspection
Annually
Control
Compartment &
firebox Top
Annually
Burner Ignition
& Operation
Annually
When properly maintained, your stove will give you many
years of trouble-free service.
Contact your dealer to answer
questions regarding proper operation, troubleshooting
and service for your appliance. Visit www.quadra-fire.com
to locate a dealer. We recommend annual service by a
qualified service technician.
A. Maintenance - Frequency and Tasks
GLASS IS BREAKABLE.
• Avoid striking, scratching or slamming glass.
• Avoid abrasive cleaners.
•
DO NOT clean glass while it is hot.
•
Prepare a work area large enough to accommodate fixed
glass assembly and door frame by placing a drop cloth on
a flat, stable surface.
Note: Fixed glass assembly and gasketing may have
residue that can stain carpeting or floor surfaces.
• Remove safety barrier
• Remove front door by pulling foward and down on latches
located at the underside of door. Slide bottom of door away
from appliance and pick up.
CAUTION! Risk of Injury! Door is very heavy. Handle with
care.
• Clean glass with a non-abrasive commercially available
cleaner.
- Light deposits: Use a soft cloth with soap and water.
- Heavy deposits: Use commercial stove glass cleaner
(consult with your dealer).
• Reinstall the glass frame by reattaching the Phillips head
fasteners. Tighten until snug. Do not overtighten.
• Reinstall front Door.
• Reinstall safety barrier
Handle glass assembly with care.
NOTE: Clean glass after initial 3-4 hours
operation.
Longer operation without cleaning
glass may cause a permanent white film on
glass.
CAUTION
!
When cleaning glass door:
• Avoid striking, scratching or slamming glass.
• Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white film.
• Do NOT clean glass when hot.
• Turn off appliance after 3-4 hours of operation and ALLOW
TO COOL.
• Remove and clean glass assembly.
• Replace glass assembly and operate appliance for additional
12 hours.
Refer to maintenance instructions.