Quadra-Fire VOYA-GRAND-MBK Installation Manual - page 21
March 17, 2014
7063-513
21
VOYAGEUR
StandardSize:42-1/2in.Wx30in.H
LargeSize:48in.Wx34in.H
Included in Surround Kit:(2)sidepieces,leftandright;(1)l
toppiece;(1)fastenerpackage.
Included in Cast Trim Kit: (2)casttrimlegs,leftandright;(1)
casttrimheader;(2)casttrimfooters,leftandright;(1)fastener
package.
Tools Needed:Powered 4 to 6 inches long Phillips head
screwdriver;pliers
1. Removecontentsfromboxbeingcarefulnottoscratchor
damage the cast trim pieces.
2
. Laysurroundfacedownonaprotectedsurfacetoprevent
scratching.
3. Usinga4to6incheslongPhillipsheadscrewdriverattach
thesidesurroundstothetopsurroundusing(2)#8sheet
metalscrewsoneachsideprovidedwiththekit.
4
. Placethepeelandstickroundfeltvibrationinsulationpads
on the front side in each corner of the top metal piece and
onthebacksideineachcornerofthetopcastpiece.
Figure
21.1.
5. Place the corresponding cast trim pieces (2 cast trim sides
and1casttrimheader)underneaththepanelset,alsoface
down.Aligntheholesinthemetalpieceswiththe5bosses
onthetopcastpieceand2bossesoneachsidepiece.
6. Securethemagnettothebracketandattachthemagnetand
brackettoeachmetalsidepieceatthebottom.Themagnet
G. Standard Surround & Cast Trim Kit
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Cast Footers,
Left & Right
Figure 21.1
Back
of
Side
Piece
Magnet Attached - Faces Front
Clearance Notch
is facing the front.
Figure 21.2.
7. Place the cast footers under the metal sides aligning the top
andbottomholesinthecastfootersandmetalsides.
8. The9mountingclipsareshippedinonelongstrip.Hand
breakapartorusepliers.
9. Each clip has a clearance notch to allow room for the cast
on the insert. Place the clip so the notch is facing the outer
edges of the surrounds.
Figure 21.3.
10.Itisbesttoinstallallofthe1/4-20screwsonlyhalfwayat
firsttoallowforadjustments.Afteradjustment,tightenthe2
screwsineachcastfooterfirstandthenworkyourwayaround
to the rest.
11.Slidesurroundandtrimoverthetopoftheinsertintoplace
matchingthemountingtabsonthemetalsideswiththeslots
on the insert.
Figure 21.4.
12
. Align the 2 screws in the top metal surround piece to the
2 alignment holes on the appliance top. Secure in place.
Figure 21.4.
Figure 21.2
Figure 21.3
Match Mounting
Tabs to Slots on
the appliance
Figure 21.4