Quadrone Maximus Instruction Manual - page 6
Assembling the Drone
Charging Your Drone
Installing the Camera
1. Use the included screw driver to open the battery cover. Rotate
counter clockwise to loosen screw.
2. Insert 6 AA batteries into the remote. Make sure the batteries are
installed in the correct polarity as indicated in the controller. Do not
mix old and new batteries or batteries with different chemistries.
3. Reattach battery cover.
1. Before installing the camera to the drone, make sure the SD card is
properly inserted into the camera.
2. After the SD card is inserted, plug the camera’s plug into the
drone’s port as shown in the image.
3. Insert the camera’s plug into the drone’s spcketto connect the two.
5
1. To install the landing gear, simply insert the
landing gear into the bottom of the drone. The
landing gear will snap in when fully inserted.
2. To install the crash guards, insert them into the
slots at the end of each arm. Use the provided
screw and screwdriver to secure the guard
in place.
1. Ensure the drone is powered OFF. 2. Open the battery compartment.
3. Unplug the battery and
remove it from the drone.
4. Connect the battery to
the included USB charger.
5. Plug the USB charger into
any USB port. The light on the
charger will flash green to
indicate the battery is charging.
When the light stops blinking and
stays on, charging is complete.
*The drone’s battery will take up to 3 hours to fully charge.
6. Reinsert the battery into the
drone and close the cover.