Quaduro QuadPad 3G PRO User Manual - page 22
10. Th
e Wir
e
l e
ss
L A
N
is
c
o n
n e
c
t e
d,
but
I can
n ot
c
o n
n e
c t t o or
t
o a
n o t h e
r com
p u t e
r.
Solution:
◊ Check the device driver is properly installed.
◊ Check that the device driver is properly installed. If the driver is not properly installed, you will
find a yellow exclamation mark on the network icon by clicking Start > Control Panel >
System > Device Manager > Network Adapters. If there is a yellow exclamation mark,
please reinstall the device driver with the system software Media.
11. Th
e si
g
n a
l str
e
n g t h is
e
x c e
l l
e
n t but
ca
n
n ot
c
o n
n e
c t t
o t h e n e
t w
or
k .
Solution: Check the TCP/IP properties are configured properly. When you connect to an AP, click the
Wireless Network Connection icon on the taskbar and select the Support tab.
12. Cont
a
c ti n g Y o u r D
ea
l e
r
If you still have a problem after reading the preceding section, the next step is to contact your dealer.
Your dealer can determine if the problem is something that requires the computer to be taken to the
shop. Before you call your dealer, however, please have the following information available:
Solution:
◊ How is your computer configured? Your dealer needs to know what peripheral devices you are
using.
◊ What messages, if any, are on the screen?
◊ What software were you running at the time?
◊ What have you done already to try to solve the problem? If you have overlooked a step, your
dealer may be able to solve the problem over the phone.
13. What
st
e
ps
sh
o
u ld
be
ta
k e n w
h e
n wa
t e
r a
cc
id
e n t a
lly
g e
t i n side
t
h e
T a
bl
e
t PC
Solution:
◊ At this time be sure not to power on the Tablet PC or else it will cause more serious damage to
the computer
◊ Unplug the adapter and take out the battery. Disconnect as well if there are any external devices
connected (like CD-ROM or flash drive)
◊ Pour out the water that got inside the computer and use a soft cloth to remove the stain to avoid
any more damage
◊ Use the fan to dry the whole system and any peripheral then send it to the closest service centre
for experienced personnel to diagnose and repair. This will reduce the damage to the system
◊ As a special reminder, be sure not to put the computer inside the carry bag that has stain in
sending the computer for repair
14. Th
e T
a
bl
e
t PC
c o
u
ld
n o t r e
s
u me
a
f t e
r it e
n t e
r ed
St
a
n d b y m
ode
Solution:
◊ Standby Mode – allows the computer or program save into the RAM. The system will enter the
saving mode. Press any key to resume the system
◊ Hibernate Mode – allows the computer or program save into the HDD. At this time the power is
completely turn off. Press any key to resume the system