Quaduro QuadPad 3G PRO User Manual - page 5
Safet
y Notices for t he Powe
r Cord
This equipment has a 3-wire power cord. Replace the power cord if it becomes damaged. Contact your dealer for
an exact replacement.
In the U.S.A. and Canada, the power cord must be a UL-listed detachable power cord (in Canada, CSA-certified).
3-wire cord SVT or SJT, 18 AWG, 3-conductor
Provided with a molded-on cord connector body at the other end. The cord length must not exceed 3 meters.
Outside the U.S.A. and Canada, the plug must be rated for 250 VAC, 2.5 amp minimum, and must display an
international agency approval marking. The cord must be suitable for use in the end-user’s country. Consult your
dealer or the local electrical authorities if you are unsure of the type of power cord to use in your country.
Voltage changes occur automatically in the power supply.
Notice o
f E
MC Comp
l
ia
nce
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in
accordance with the instruction manual may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
◊ Reorient or relocate the receiving antenna.
◊ Increase the separation between the equipment and receiver.
◊ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
◊ Consult the dealer or an experienced technician for help.
◊ Use only shielded I/O cables to connect I/O devices to this equipment.
You are cautioned the changes or modifications not expressly approved by the party responsible for compliance
could void your authority to use the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device will not cause harmful interference, and (2) this device must accept any interference it receive including
interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter.