Qualcast GT2518 Instruction Manual - page 12
12
Customer Helpline 08456 400 800
Fitting a New Spool of Cutting Line
Maintenance
You tool has been designed to operate over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool care and regular cleaning.
WARNING!Before performing any maintenance, switch off and unplug the tool.
Regularly clean the ventilation slot in your tool using a soft brush or dry cloth.
Regularly clean the cutting line and spool using a soft brush or dry cloth.
Regularly use a blunt scraper to remove grass and dirt from the underneath of the guard.
Unplug the tool
• Depress the tab on the side of the spool cover and remove the spool cover
1
from the housing
3
.Remove the empty spool
2
from the housing.
• Remove any dirt and grass from the spool cover and housing. Insert the new spool and push It into
the boss in the housing.
• Unclip the end of cutting line
4
and guide the line into the eyelets in the housing. The line should
protrude approx. 10cm from the housing.
• Align the tabs on the spool cover with the outlets in the housing.
Push the cover onto the housing until it snaps securely into place.
WARNING!If a cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the
blade.
7
8
1
1
2
2
3
3
4
4