Qualcast MEB1234M Instruction Manual - Usage
Curved handle assembly (Fig. 2b)
- The top, curved handle section (5) is assembled to the bottom supports (10)
using a bolt, washer and quick release fastener (6) on either side. Three
height positions are possible. Adjust as necessary.
- These fasteners should be folded in towards the bar using moderate force
in order to lock them into position. When locked there should be no play
between the top and bottom handle assemblies.
To tighten, first unfold the lever- turn clockwise or to loosen - turn
anticlockwise, then fold them back in. Several adjustments might be
needed to find the correct setting. Do not force.
Grass collector assembly (Fig. 3a to 3d)
- Push the rubber clips of the grass collector (16) into the openings around
the edges of hard plastic top of the grass collector
- Insert the rods on the metal frame (18) into the grass collector (17). Make
sure to fully insert the rods. Then fit the metal frame into the plastic
retainers (20) around the edges of grass collector.
- Use the screws and washers (21) provided to lock the frame in place (18).
Usage
Attention: Do not operate the mower until the deflector guard and
grass collector are fully installed. Risk of injury!
Fitting / removing the grass collector (Fig. 3e)
- Lift the deflector guard (12)
- Place the grass collector on the mounting bracket (22) at the back of the
lawn mower.
- Lower the deflector guard (12) onto the grass collector – a spring tensioner
holds it in place.
- To remove the grass collector, lift the deflector guard (12) and unhook the
grass collector from the mounting bracket. Ensure the deflector returns
down to its original position.