Model: qt6206b/r/w instruction manual corded analogue telephone before operating this telephone instrument please read the following instructions carefully.
2 introduction thank you for purchasing a qualitel product which adopts excellent workmanship and exceptional reliability. Your telephone is designed to give you flexibility in use and high quality performance. To get the most from your new telephone, we suggest that you take a few minutes to read t...
3 ¾ hands free speaker phone ¾ redial and auto-redial function ¾ lcd blue backlight (this feature will work only if batteries are inserted in the battery compartment)..
Ringer volume switch.
5 installation 1. Plug one end of the line cord into the connector marked “line” on the base of the telephone and the other end into the wall socket. 2. Plug one end of the curly cord into the handset and the other end into the handset connector on the side of the telephone base. 3. Select your pref...
6 pre-dialing function 1. Without lifting the handset, dial the desired number using the numerical dial pad. 2. If a digit was entered incorrectly, use the del key to delete the digit. 3. Press the key or pick up the handset for the number to be dialed automatically. Redial 1. Pick up the handset or...
7 3. Press the rd key, the number will be dialed out automatically. ¾ deleting outgoing call number 1. In on-hook or off-hook state, press the out key to review the stored number. 2. Press the del key to erase the lcd displays the next number. Note: press the del key for 3 seconds, all the outgoing ...
8 note: normally the dialing mode should be set to t (tone dialing). Setting anti-dialing function 1. In on-hook state, press the set key and then press ▲ key five times, the lcd displays set 6 alar 2. Press the set key to confirm, the lcd displays alar off, press ▲ or ▼key to select on or off. 3. P...
9 lcd blue backlight function the backlight will be turned on upon receipt of an incoming call, dialing, pressing any key or in music on hold state, etc. The backlight will disappear if the telephone is left idle for more than 6 seconds. Note: in order for this feature to operate, batteries must be ...
