Qualitel QT6206B Instruction Manual - page 8
8
NOTE:
Normally the dialing mode should be set to T (Tone dialing).
SETTING ANTI-DIALING FUNCTION
1. In on-hook state, press the SET key and then press ▲ key five times, the LCD displays SET 6 ALAR
2. Press
the
SET
key to confirm, the LCD displays ALAR OFF, press ▲ or ▼key to select ON or OFF.
3. Press
the
SET
key to confirm.
When the anti-dialing feature is set to ON, calls can not be made from a parallel extension.
SETTING LCD CONTRAST
1. In on-hook state, press the SET key and then press ▲ key seven times, the LCD displays SET 7 LCD
2. Press
the
SET
key again; the LCD displays LCD 3, press ▲ or ▼to select among 1~5 contrast settings.
3. Press
the
SET
key to confirm and exit.
SETTING RINGING TONE
There are 8 selectable ring tones.
1.
In on-hook state, press the HOLD/RING key, the LCD display RING 01.
2. Press
▲ or ▼ key to select the preferred ring tone.
Alternatively you can press the HOLD/RING key repeatedly to select a ring tone.
MUSIC ON HOLD
A) HANDSET:
1. When using the handset during a conversation, press the HOLD/RING key to put the call on hold and the other
party will then hear music.
2. Press
the
HOLD/RING
key again to cancel hold and continue the conversation over the handset.
3. Or hang up the handset, and enter into Hands-free hold mode.
B) HANDS FREE:
1. During a conversation in Hands-free mode, press the HOLD/RING key to put the call on hold, the other party
will hear music.
2. Pick up the handset, the hold mode is cancelled and normal conversation is continued.
3. Or press the HOLD/RING key again or
key to cancel the hold mode and continue with Hands-free
conversation.
FLASH FUNCTION
The FLASH key can be used behind a PABX to transfer calls. To transfer a call to another extension press the
FLASH
key followed by the extension number.
NOTE: The flash time must be set to match the PABX flash time (normally 100ms).
RING VOLUME SWITCH
To adjust the ringer volume, set the ring switch underneath the telephone to HI (High), LO (Low) or OFF (the ringer
is then off and the telephone will not ring upon receipt of an incoming call).