Summary of TORINO
Page 2
1 introduction thank you for purchasing our product which adopts excellent workmanship and exceptional reliability. Your telephone is designed to give you flexibility in use and high quality performance. To get the most from your new telephone, we suggest that you take a few minutes to read through ...
Page 3
2 ¾ transfer function between parallel phones(using 2 similar models) ¾ secret code function in do not disturb state to avoid missing important calls ¾ pre-dial and edit function ¾ redial function ¾ 2-step lock function ¾ lcd contrast adjustable ¾ selectable flash time (100/300/600/1000ms) ¾ alarm c...
Page 4
3 location description.
Page 5
4 getting started 1. The unit requires 3×1.5v aa batteries. Open the battery compartment cover and insert the batteries, observe the polarity, then close the cover (proposal use alkaline batteries). The time should be displayed on the liquid crystal screen after the batteries are inserted. 2. Insert...
Page 6
5 ¾ from the speakerphone 1. Press key 2. When you hear the dial tone, dial the desired number. 3. The telephone will start to time the conversation after 6 seconds. 4. To end the call, press key again. ¾ pre-dialing function 1. When the handset is on the base, dial the desired number. 2. If a mista...
Page 7
6 setting menu ¾ setting date & time 1. In on-hook state, press the set key, the lcd displays set 1 date. Press the set key again, the year flashes on the lcd display. 2. Press ▲or ▼ key to edit the year. 3. Press the set key to confirm and enter into the month setting. 4. Repeat the above procedure...
Page 8
7 displays pcode - and the “-” flashes. 2. Press ▲or ▼key to enter the pabx code from 0 to 9 or -. 3. If no number is entered -”, it means no pabx code has been set. 4. Press the set key to confirm and quit. ¾ setting alarm clock 1. In on-hook state, pressthe p/alm key once, the lcd displays 12-00 a...
Page 9
8 transfer between parallel phones ¾ setting the paging number 1. In on-hook state, press and hold the set key, the lcd displays el-- 2. Key in “*” and the paging number (example “*1”and ”*2” ), use the del key to edit 3. Press the set key to confirm and exit. ¾ transferring a call to paralleled pho...
Page 10
9 set as pulse. 2. Press * key once again, the lcd displays t, the dialing mode is set as tone. Press the set key to confirm. Mute function by pressing the mute button during a conversation, the other party can not hear your conversation. Press the mute button again to restore the conversation. Musi...
Page 11
10 under the selected number on the numeric keypad. ¾ make a call from two-touch memory in on-hook state, press the store key + numeric key (0-9) on the numeric keypad , the lcd displays the stored number, press orthe redial key or pick up the handset to dial the number, or press the redial key twic...
Page 12
11 phone does not ring * check the phone line cord * could have too many phones on one line (the total ren of all phones should not be greater than the maximum for your area, usually 5). * check if the ringing volume is set to db0 last number redial and/ * when you first make a call try pressing the...