Qualitel TORINO Instruction Manual - page 5
4
GETTING STARTED
1. The unit requires 3×1.5V AA batteries. Open the battery compartment cover and insert the
batteries, observe the polarity, then close the cover (Proposal use alkaline batteries). The
time should be displayed on the liquid crystal screen after the batteries are inserted.
2. Insert one end of the line cord into the connector marked “line” at the base of the telephone,
insert the other end into the wall outlet.
3. Connect the one end of the curly cord to the handset and the other end to the base of the
telephone.
4. Set the dialing mode to PULSE or TONE depending on the service providers requirements.
5. Apply for caller identification from your service provider.
RECEIVING A CALL
1.
On receipt of an incoming call, the telephone rings, and the LCD displays the callers number,
the date, time, incoming number andthe NEW icon.
2. If the same number is received again, and the previous call has not been reviewed, the LCD
displays REP icon.
When the incoming memory is full, the latest incoming number replaces the oldest number in
the memory.
NOTE: For the phone to display incoming numbers and other information, you must have
an active Caller ID subscription with your service provider.
¾
From the handset
1. Pick up the handset and talk to the other party.
2. To end the call, return the handset to the base.
¾
Switching to speakerphone
1. When using the handset, press
key and return the handset to the base.
2. To end the call, press
key again.
¾
From the speakerphone
1. When the telephone rings, press
key and talk to the caller. For the other party to hear your
voice clearly, speak from a distance of not more than 32cm from the telephone.
2. To end the call, press
key again.
MAKING A CALL
¾
From the handset
1. Pick up the handset.
2. When you hear dial tone, dial the desired number.
3. The telephone will start to time the conversation after 6 seconds.
4. To end the call, return the handset to the base.