Attention: 1. Find a location for the fireplace heater that is protected from direct sunlight. 2. Do not plug the unit into the power outlet before reading all instructions . Electric fireplace heater i n s t r u c t i o n m a n u a l m450p-32ach (ndf-65nb-1).
2 s a f e t y i n s t r u c t i o n s important please note when you open the carton carefully check the unit and make sure there are no damages. If you have any problems with the unit, with how the various functions work or with hidden damages or missing parts please call 1-800-459-4409 (est) immed...
3 8) do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over. 9) to disconnect fireplace, turn controls to off, then remove plug from outlet. 10) connect to properly grounded outlets ...
4 a 15 amp circuit is required to operate this heater. If the breaker trips when the heater is used then you may need to move the heater to another location or unplug other appliances that are on the same circuit. If you require an extension cord use one that is rated at 1875 watts. Save these instr...
5 please do not fully tighten the kd screws until all panels are assembled. Step 1: attach 2 connector [s] to the front panel [d] with 4 kd screws. (2 screws for each side) see fig. A. Fig. A step 2: attach all plastic connector [x] to the panels [c, d and e] as shown in fig. B. (2 screws for each p...
6 fig. E step 6: carefully place the insert into the unit opening. The front of insert should be flush with the front of the mantel. Once the insert is in place, attach 2 mounting brackets [v] with 2 kd screws onto the bottom of insert. (1 screw for each bracket) see fig. F. Fig. F step 7: attach th...
7 fig. I step 10: tighten all kd screws. Step 11: carefully move the assembled unit to the desired location. The fireplace mantel should not be positioned in area exposed to direct sunlight. Wall anchor safety cable the use of wall anchor safety cable is highly recommended in order to reduce the ris...
8 o p e r a t i o n on/off: press this button for main power and flame effect. The indicator light will turn on. See below for other control switches. 750w: for low heat function - press this switch while the on/off switch is in the on position for low heat. The indicator light will turn on. 1500w: ...
9 m a i n t e n a n c e risk of fire: do not exceed the recommended bulb wattage. Replacing the light bulbs step 1: remove 4 screws on the back of fireplace and remove the rear cover of the unit. Step 2: you will find 2 x 40w type b-10 bulbs under log-set bed. Step 3: loosen and remove burnt out bul...
10 option 1: use the spare kd nuts, kd screws and plastic connector 1. Place the plastic connector on the mantel unit and mark the drill-holes as shown in fig. B. Fig. B 2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10mm) on the mantel. Each plastic connector needs 3 hole...
11 2. Drill the holes with diameter 1/16 inches (2 mm) and depth 5/16 inches (8mm) on the mantel. Each small l-bracket needs 4 holes. See fig. G. Fig. G fig. H 3. Attach the small l-bracket and lock in place with screws as shown in fig. H. Cleaning to clean unit first turn off controls on unit and u...
