Quality Craft M450P-32ACH Instruction Manual - page 5
5
Please DO NOT fully tighten the KD screws
until all panels are assembled.
Step 1: Attach 2 CONNECTOR [S] to the FRONT
PANEL [D] with 4 KD SCREWS.
(2 screws for each side) See Fig. A.
fig. A
Step 2: Attach all PLASTIC CONNECTOR [X]
to the PANELS [C, D and E] as shown in Fig.
B. (2 screws for each PLASTIC CONNECTOR).
fig. B
NOTE: If the KD SCREW(S) do not fit during
assembly, loosen the 2 screws to adjust the
PLASTIC CONNECTOR until the PANELS/KD
SCREWS can be installed.
Step 3: Attach the SIDE PANELS [C] to the
FRONT PANELS [D] with 4 KD SCREWS as
shown in Fig. C. (2 screws for each side).
fig. C
Step 4: Attach the LEFT and RIGHT SIDE
PANELS [C and D] to the BASE [B] using 4
KD SCREWS. (2 screws for each side) See
Fig. D.
fig. D
Step 5: Place the LOWER FRONT PANEL [F]
in between the lower section of 2 FRONT
PANELS [D] and attach with 2 KD SCREWS (1
screw each side). See Fig. E.
A S S E M B LY I N S T R U C T I O N S