Quality Craft M707P-2628FCN Instruction Manual - page 9
9
O P E R A T I O N
TEMPERATURE CONTROL: To adjust the
temperature to your individual require-
ments, turn the temperature control dial to
the right (clockwise) to increase the desired
temperature and to the left for lower tem-
perature. This temperature control dial can
only be used while the O/I switch and 1250W
switch are in the ON position.
NOTE: When the O/I switch is turned off, the
heater functions will stop even though the
switches may be in the ON position.
MAINTENANCE
WARNING: Disconnect power and unplug
the power cord before attempting any main-
tenance or cleaning to reduce the risk of fire,
electric shock or damage to persons. The
bulbs in your unit can become extremely
hot. Allow at least 10 minutes between turn-
ing off the unit and removing the light bulbs
to avoid the accidental burning of the skin.
RISK OF FIRE: DO NOT EXCEED
THE RECOMMENDED BULB
WATTAGE.
REPLACING THE FLAME
EFFECT LIGHT AND
LOG-SET LIGHT BULBS
Step 1: Remove 12 screws on the back of
fireplace and open the rear cover. There are
2 larger screws and 10 smaller screws.
Step 2: You will find 1 X 40W Type B-10 bulb
under log-set bed.
Step 3: Loosen and remove the burnt out
bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the 2
larger screws into the top left corner hole
and bottom right corner holes as shown in
the diagram. Secure the 10 smaller screws
into the remaining holes. Make sure the
screws are in the correct holes and have
been tightened.
Step 5: Plug in the unit.
REPAIR SET