Quality Craft MM931-44FBK Instruction Manual

Summary of MM931-44FBK

  • Page 1

    1 important: please note when you open the carton carefully check the unit and make sure there is no damage. If you have any problems with assembling the unit, with how the various functions work or with damage or missing parts please call 1-800-459-4409 (9:00am - 5:00pm est) immediately for service...

  • Page 2

    2 times. The fireplace heater has safety overheat protection. If the overheat protection trips, turn off all switch buttons and wait approximately 5 -10 minutes. It should reset automatically once the unit cools down. Warning: procedures and techniques if not carefully followed will result in damage...

  • Page 3

    3 mantel assembly: caution: place a piece of cardboard or protective sheet on the floor in order to avoid scratching the decorative surface of your mantel during assembly. Please do not fully tighten the kd screws until all panels are assembled. Step 1: attach 12 plastic connector [x] to left front ...

  • Page 4

    4 fig. E step 6: attach top panel [a] to the unit as shown in fig. F with 4 kd screws. See fig. F fig. F step 7: tighten all kd screws. Fireplace insert installation: the fireplace insert can be installed after the mantel has been fully assembled. Warning: make sure the fireplace insert controls are...

  • Page 5

    5 2. Position the back edge of the mantel close to the wall. 3. Attach the safety cable to the mantel using the screw for mantel. 4. Use the screw for wall to attach the other end of safety cable to the wall. 5. Make sure all screws are tight. Wall operation after reading complete instructions, conf...

  • Page 6

    6 repair set touch-up repair paint paint directly on the mantel unit if necessary. Fig. A fig. A repairs if any problems are found with the original parts during mantel assembly such as the panels cannot be installed with the plastic connector. Try to solve by one of the following methods. Tools req...

  • Page 7

    7 fig. E option 2: use the small l-brackets and screws 1. Place the small l-bracket to the unit as shown and mark the drill-holes on the mantel as shown in fig. F. Fig. F 2. Drill the holes with diameter 1/16 inches (2 mm) and depth 5/16 inches (8mm) on the mantel. Each small l-bracket needs 4 holes...