Quality Craft MM931-44FBK Instruction Manual - page 3
3
MANTEL ASSEMBLY:
CAUTION: PLACE A PIECE OF CARDBOARD OR PROTECTIVE
SHEET ON THE FLOOR IN ORDER TO AVOID SCRATCHING THE
DECORATIVE SURFACE OF YOUR MANTEL DURING ASSEMBLY.
PLEASE DO NOT FULLY TIGHTEN THE KD SCREWS UNTIL ALL
PANELS ARE ASSEMBLED.
Step 1: Attach 12 Plastic connector [X] to Left front panel [E],
Right front panel [F], Left side panel [G] and Right side panel [H]
with 24 KD screws (2 screws for each connector). Attach 2 Wood
connectors [P] to Left front panel [E] and Right front panel [F] with
4 KD screws (2 screws for each connector) See Fig A.
Fig. A
Step 2: Attach Left side panel [G] to Left front panel [E] with 2
KD screws. Attach Right side panel [H] to Right front panel [F]
with 2 KD screws. See Fig. B.
Fig. B
Step 3: Attach Left front panel [E] and Left side panel [G] to base
panel [B] with 2 KD screws. Attach Right front panel [F] and Right
side panel [H] to Base Panel [B] with 2 KD screws. See Fig. C.
Fig. C
Step 4: Attach Lower front panel [D] to Left front panel [E] and
Right front panel [F] with 2 KD screws. See fig. D
Fig. D
Step 5: Attach 2 plastic connectors [X] to Upper front panel [C]
with 4 KD screws (2 screws for each connector). Attach Upper
front panel [C] as shown in Fig E with 6 KD screws. See fig. E